ROHN FRM238SP5 Non-Penetrating Roof Mount 2.375 x 60 inch Mast
Made in the USA!
This roof mount is able to support various Antenna EPA's depending on wind and Ballast load (see details). The base of the roof mount is 3’ square with a 16” tray to fit concrete blocks, typically used as ballast for placement of various TV, Radio, Microwave, WiFi and Wireless Internet Antennas. The base mount is 16 gauge Pre-Galvanized and the mast tube is thick-walled galvanized steel for corrosion protection and go together quickly. Antenna and wind loads vs ballast weight are found in the spec sheet below.
Height and Antenna Loading capability are dependant upon ballast weight... You need to Consult an Engineer to determine the Load Bearing Capability of the roof that you are entertaining such an Installation. Please refer to the Chart (pdf link above) which is a great place to start in determining whether your circumstances qualify for such an installation. If you cannot find someone local to evaluate the registered plans for your Flat Roof Structure, ROHN may be able to put you in contact with someone who can.
FRM-MAT Satellite Dish Non-penetrating Roof Mount Rubber Protective Mat
A Protective Layer between the Roof Surface and the Non-Penetrating Roof Mount before Installation. This 3/32 thick Pad measures roughly 36 wide by 42 inches long, trims neatly, place underneath Frame of Non-Penetrating mount, on top of Roof surface...
ROHN offers non-penetrating roof mounts to meet a variety of communication tower needs such as Cellular, PCS, Wireless Cable, Microwave, Wireless Internet, WiFi Hot Spots, DBS, MDS, MMDS and UHF/VHF network interlink, broadcast and reception patterns.
Designed and engineered to handle the job of getting above ground interference, each non-penetrating roof mount has been researched and developed to serve a specific purpose based on antenna type, size, weight and windload commensurate with height needed for line of sight reception .
With professionally engineered construction, you can be assured you're getting a virtually maintenance-free product built to the highest standards. And because our non-penetrating roof mounts are hot-dip galvanized after fabrication, our roof mounts won't rust like pre-galvanized, lighter load antenna mounts..
Additional features inculde:
Ballast Requirement Information
Effective Wind Velocity Formula Sheet
This Buyers Guide has will answer many questions you may have on this Product Line. Look for more detailed information and Specification Sheets covering the wind load capabilities of each. Apply the EPA or Square measurements of your Antenna to the Charts contained therein to determine style, height and ballast.
Call 877-660-0974 at anytime for assistance.
1. ROHN FRM238SP5 Non Penetrating Roof Mount FRM238SP5 - $198.00 | 2. ROHN 45GSR Complete 340 Foot 110 MPH Guyed Tower R-45GSR110R340 - $44,144.00 |
3. Thomas & Betts TNB4009 9 inch Copper Ground Strap - $4.95 |
New Store to Open 2024
Three Star Inc.
5750 Stuart Ave.
Jacksonville, FL 32254
Your Orders are Currently being Processed and Shipped out of Richmond, VA.